412-00-40 Climate Control System — General Information 412-00-40
GENERAL PROCEDURES
Air Conditioning (A/C) Clutch Air Gap Adjustment (34 628 6)
Material
Specification
Spacer washer set
1. Check the air gap A between the drive plate
and the pulley at 60 degrees intervals
around the circumference. For additional
information,
refer to Specifications. in this section
1. Belt pulley
2. Spacer washer
3. Drive plate
NOTE: The refrigerant circuit can remain closed
if possible.
2. If the air gap A is outside the tolerance
range, if necessary detach the air
conditioning compressor. For additional
information, refer to Section 412-02/ 412-03.
• Tie up the compressor with wire if
necessary.
3. Detach the drive plate.
4. Correct air gap A as necessary using
spacer washers.
5. Attach the drive plate.
6. Check air gap A as described in step 1.
Repeat steps 3-6 if necessary.
7. Install the air conditioning compressor.
For additional information,
refer to Section 412-02 / 412-03.
E3640 EN 07/2001 2002 Bantam
To Next Page
Loading...
