413-01-15 Instrument Cluster 413-01-15
DIAGNOSIS AND TESTING (CONTINUED)
PINPOINT TEST F: THE LOW OIL PRESSURE INDICATOR IS INOPERATIVE
CONDITIONS
DETAILS/RESULTS/ACTIONS
F1: TEST OPERATION OF LOW OIL PRESSURE WARNING INDICATOR
1.
2.
• Does the low oil pressure warning indicator
illuminate?
Yes
GO TO F2
No
INSTALL a new instrument cluster. TEST
the system for normal operation.
F2: CHECK OPERATION OF OIL PRESS RE SWITCH U
1.
2.
Oil Pressure Switch
C3
3.
4 Connect a jumper wire between the oil
pressure switch C3 pin and ground.
• Does the low oil pressure warning indicator
illuminate?
Yes
INSTALL a new oil pressure switch. TEST
the system for normal operation.
No
REPAIR circuit 31S-WD9 (BK/GN) OR 31-
PC2C (BK). TEST the system for normal
operation.
PINPOINT TEST G: THE BRAKE WARNING INDICATOR IS INOPERATIVE – FROM 01/99
ONWARDS
CONDITIONS
DETAILS/RESULTS/ACTIONS
G1: TEST OPERATION OF BRAKE WARNING INDICATOR
1 Select the instrument cluster self-diagnostic
mode test 3 – illuminate warning indicators.
• Does the brake warning indicator illuminate?
Yes
GO TO G2
No
INSTALL a new instrument cluster. TEST
the system for normal operation.
E1282 EN 09/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM PAGES FROM MANUAL
TO MODEL INDEX
To Next Page
Loading...
