206-02-8 Drum Brake 206-02-8
REMOVAL AND INSTALLATION (CONTINUED)
E6595 EN 07/2001 2002 Bantam
Installation
1. Clean, check and apply grease to the
backing plate contact points.
2. Install the strut support to the secondary
brake shoe.
1. Install the spring.
2. Rotate the brake shoe through 90
degrees into position.
3. Install the primary brake shoe to the strut
support.
1. Position the brake shoe.
2. Push the primary brake shoe onto the
support.
4. Install the brake shoe return springs.
1. Install the upper return spring.
2. Install the lower return spring.
To Next Page
Loading...
