501-10-7 Seating 501-10-7
REMOVAL AND INSTALLATION
Front Seat Cushion
Removal
1. Remove the front seat. For additional
information,
refer to Front Seat in this
section.
2.
CAUTION: Note the position and
routing of the safety belt buckle pre-
tensioner wiring harness to aid
assembly. An incorrectly routed
wiring harness may lead to the wiring
harness becoming damaged on the
seat mechanism.
Detach the safety belt buckle pre-tensioner
wiring harness from the underside of the
seat.
• Detach the clips.
3. Remove the front seat cushion.
• Remove the bolts.
Installation
1. To install, reverse the removal procedure.
E9365 EN 07/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
BACK TO CHAPTER INDEX
To Next Page
Loading...
