Ford 2002 Bantam - Vibration When Brakes Are Applied

206-00-8 Brake System — General Information 206-00-8
DIAGNOSIS AND TESTING (CONTINUED)
E1092 EN 07/2001 2002 Bantam
CONDITIONS
DETAILS/RESULTS/ACTIONS
B3: CHECK BRAKE WARNING SWITCH OR WIRING
1.
2 Remove the brake master cylinder reservoir
filler cap or switch. Allow the float to rest at its
lowest (maximum) point.
• Does the brake warning indicator illuminate?
 Yes
The switch or wiring is OK. TEST the
system for normal operation.
 No
REFER to Section 413-01.
PINPOINT TEST C: VIBRATION WHEN BRAKES ARE APPLIED
CONDITIONS DETAILS/RESULTS/ACTIONS
C1: ROAD TEST THE VEHICLE
1 Road test the vehicle without applying the
brakes at 40-80 km/h.
• Is a vibration present?
 Yes
REFER to Section 100-04. After servicing.
TEST the system for normal operation.
 No
GO TO C2
C2: CHECK FOR REAR BRAKE VIBRATION
NOTE: With a manual release parking brake control, hold the parking brake control release button in
the release position during parking brake control application.
1 Road test the vehicle at 40-80 km/h with a
medium application on the parking brake
control.
• Is a vibration present?
 Yes
CHECK the rear brake drums for excessive
wear. INSTALL new components as
necessary. TEST the system for normal
operation.
 No
GO TO C3