Ford 2002 Bantam - No Power in Run; C1: Check Fuse 38 (60 A); C2: Check for Short to Ground on Circuit 30 (Rd); C3: Check the Ignition Switch

211-05-101 Steering Column Switches 211-05-101
DIAGNOSIS AND TESTING (CONTINUED)
PINPOINT TEST C: NO POWER IN RUN
CONDITIONS DETAILS/RESULTS/ACTIONS
C1: CHECK FUSE 38 (60A)
1.
2 Check the fuse 38 (60A).
• Is the fuse OK?
 Yes
GO TO C3
 No
INSTALL a new fuse 38 (60A). TEST the
system for normal operation. If the fuse fails
again GO TO C2
C2: CHECK FOR SHORT TO GROUND ON CIRCUIT 30 (RD)
1.
Fuse 38 (60A)
2.
Ignition relay C47
3 Measure the resistance between the fuse 38
connector pin 1, circuit 30 (RD) and ground.
• Is the resistance greater than 10,000 ohms?
 Yes
GO TO C1
 No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
C3: CHECK THE IGNITION SWITCH
1 Carry out the ignition switch component test.
Refer to the procedure in this section.
• Does the ignition switch test OK?
 Yes
GO TO C4
 No
INSTALL a new ignition switch. TEST the
system for normal operation.
E1227 EN 07/2001 2002 Bantam