Ford 2002 Bantam - Power Steering System Flushing (13 416 1)

211-00-8 Steering System — General Information 211-00-8
GENERAL PROCEDURES
Power Steering System Flushing (13 416 1)
Special Tool(s)
Remover, Oil Cooling Pipe
307-242 (17-049)
All vehicles
1. Raise and support the vehicle. For
additional information, refer to Section 100-
02.
2. Using the special tool, (if required)
disconnect the power steering fluid return
line.
1. Insert the special tool into the quick-
release coupling.
2. Slide the special tool along the pipe to
release the locking tangs.
• Allow the fluid to drain into a suitable
container.
3. Attach a tube of suitable length to the fluid
return line.
1. Using a suitable blanking cap, cap the
end of the fluid cooler line.
2. Attach a tube of suitable length to the
fluid cooler to power steering gear line
and place the other end into a suitable
container.
All except vehicles with diesel engine
4. Disconnect the crankshaft position sensor
(CKP) electrical connector.
Refer to the
Wiring Diagram Section 700-06
for
schematic and electrical information.
E3217 EN 07/2001 2002 Bantam