501-11-17 Glass, Frames and Mechanisms 501-11-17
REMOVAL AND INSTALLATION
Rear Window Glass
General Equipment
Hot air gun
Direct glazing cutter for bonded glass
Mixer/Application gun
Removal
1. NOTE: Should the ambient temperature fall
below 10°C heat the cartridges for
approximately 15 minutes by placing them on
a warm radiator, or by using a hot air gun set
at approximately 25°C.
Heat the polyurethane (PU) adhesive if
necessary.
2.
CAUTION: When removing fasteners,
take extreme care, as they may be
easily broken.
NOTE: Remove the headliner rear fastener
centre pins before removing the fasteners.
Detach the rear of the headliner.
• Remove the headliner fasteners.
3. Lower the headliner.
• Place two blocks of suitable material
between the headliner and the roof panel
to act as spacers.
E6780 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
BACK TO CHAPTER INDEX
To Next Page
Loading...
