Ford 2002 Bantam - Pats Transceiver Signal Is Not Received

419-01B-6 Anti-Theft — Passive 419-01B-6
DIAGNOSIS AND TESTING (CONTINUED)
E4861 EN 07/2001 2002 Bantam
Pinpoint Tests
PINPOINT TEST A: PATS TRANSCEIVER SIGNAL IS NOT RECEIVED
CONDITIONS DETAILS/RESULTS/ACTIONS
A1: CHECK THE TRANSCEIVER POWER CIRCUIT FOR VOLTAGE – CIRCUIT 7-MB37 (YE/GN)
1. 2.
PATS Transceiver
C54
3.
4 Using a digital multimeter, measure the voltage
between PATS transceiver C54 pin 1, circuit 7-
MB37 (YE/GN), harness side and ground.
• Is the voltage greater than 10 volts?
 Yes
GO TO A2
 No
REPAIR circuit 7-MB37 (YE/GN). REPEAT
the self-test. CLEAR the DTCs.
A2: CHECK THE TRANSCEIVER GROUND FOR OPEN – CIRCUIT 91-MB37 (BK/GN)
1.
2
Using a digital multimeter, measure the
resistance between PATS transceiver C54 pin
2, circuit 91-MB37 (BK/GN), harness side and
ground.
• Is the resistance less than 5 ohms?
 Yes
GO TO A3
 No
REPAIR circuit 91-MB37 (BK/GN). REPEAT
the self-test. CLEAR the DTCs.
BACK TO CHAPTER INDEX
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED