Ford 2002 Bantam - D7: Check for Open on Circuit 50 (Gy;Bk); E1: Check the Exterior Lighting; E2: Check the Wiper and Washer

211-05-106 Steering Column Switches 211-05-106
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
D7: CHECK FOR OPEN ON CIRCUIT 50 (GY/BK)
1.
Connector C188
2 Measure the resistance between start inhibit
relay connector C163 pin 5, circuit 50 (GY/BK)
and connector C188 pin 1, circuit 50 (GY/BK).
• Is the resistance less than 5 ohms?
 Yes
INSTALL a new start inhibit relay. TEST the
system for normal operation.
 No
REPAIR circuit 50 (GY/BK) TEST the sys-
tem for normal operation.
PINPOINT TEST E: THE MULTIFUNCTION SWITCH/HAZARD WARNING SWITCH DOES NOT
OPERATE CORRECTLY
CONDITIONS DETAILS/RESULTS/ACTIONS
E1: CHECK THE EXTERIOR LIGHTING
1 Operate the exterior lights.
• Do the exterior lights work OK?
 Yes
GO TO E2
 No
REFER to Section 417-01 to diagnose the
exterior lighting.
E2: CHECK THE WIPER AND WASHER
1 Operate the wipers and washers.
• Do the wipers and washers work OK?
 Yes
VERIFY the customer concern.
 No
REFER to Section 501-16 to diagnose the
wipers and washers.
E1227 EN 07/2001 2002 Bantam