Ford 2002 Bantam - Air Bag Warning Indicator Open Circuit or Short to Ground

501-20B-13 Occupant Restraints — Passive — Supplemental Air 501-20B-13
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Measure the resistance between the output
side of fuse 60 (10A) and the air bag control
module C1511a pin 8, circuit 94-JA10
(VT/OG).
• Is the resistance less than 5 ohms?
 Yes
GO TO C4
 No
CHECK the connector terminals for corro-
sion or dirt ingress. REPEAT the self-test;
CLEAR the
DTCs. REACTIVATE the sys
tem.
REFER to Air Bag and Safety Belt
Pretensioner Supplemental Restraint Sys-
tem (SRS) in this section.
C4: CHECK THE AIR BAG CONTROL MODULE GROUND CIRCUIT
1 Measure the resistance between the air bag
control module C334 pin 9, circuit 91-JA10
(BK/RD) and the air bag control module ground
G4.
• Is the resistance less than 2 ohms?
 Yes
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
 No
CHECK the air bag control module ground
G4 for security and corrosion. REPEAT the
self-test, CLEAR the DTCs. REFER to Air
Bag and Safety Belt Pretensioner Supple-
mental Restraint System (SRS) in this sec-
tion.
PINPOINT TEST D: DTC B1869: AIR BAG WARNING INDICATOR OPEN CIRCUIT OR SHORT TO
GROUND
CONDITIONS DETAILS/RESULTS/ACTIONS
D1: CHECK THE AIR BAG WARNING INDICATOR
1.
08/2001 2002 Bantam