502-00-2 Uni-Body, Subframe and Mounting Frame — General 502-00-2
Information
REMOVAL AND INSTALLATION
Subframe
Special Tool(s)
Separator, ball joint
13-006
Special Tool(s)
Guide pins, subframe
15-097A
Removal
1. Disconnect the battery ground cable.
2. From inside the passenger compartment,
remove the flexible coupling to pinion shaft
pinch bolt.
3. From inside the passenger compartment,
slacken the flexible coupling to column
shaft pinch bolt.
4. Remove the exhaust manifold upper heat
shields and remove the exhaust system
front pipe. For additional information,
refer
to Section
309-00.
5. Slacken the wheel nuts, raise the vehicle
and remove the front road wheels.
E6015 EN 08/2001 2002 Bantam
To Next Page
Loading...
