414-00-5 Charging System — General Information 414-00-5
DIAGNOSIS AND TESTING (CONTINUED)
Pinpoint Tests
PINPOINT TEST A: THE CHARGING SYSTEM WARNING INDICATOR STAYS ON
CONDITIONS
DETAILS/RESULTS/ACTIONS
A1:
1 Carry out a No-Load Component Test.
Refer to the procedure in this section.
• Is there an increase in voltage?
Yes
GO TO A2
No
GO TO A4
A2: CHECK CIRCUIT 31 (BK)
1.
2.
Generator (C303a)
3.
C1
4 Measure the resistance between the generator
connector C303a pin 1, circuit 31 (BK) and
ground.
• Is the resistance greater than 10,000 ohms?
Yes
GO TO A3
No
REPAIR circuit 31 (BK).
A3: CHECK CIRCUIT 64 BA9 (BU-BK)
1.
Instrument clus-
ter (C44b)
2.
Heated windshield
relay
E1297 EN 07/2001 2002 Bantam
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL
To Next Page
Loading...
