206-02-11 Drum Brake 206-02-11
REMOVAL AND INSTALLATION
E1100 EN 07/2001 2002 Bantam
Wheel Cylinder (12 305 0)
General Equipment
Brake hose clamp
Removal
1. Remove the brake shoes. For additional
information,
refer to Brake Shoes in this section.
2. Using a suitable brake hose clamp, clamp
the brake hose.
3. Remove the wheel cylinder.
1. Disconnect the brake hose union.
2. Remove the bolts.
3. Remove the wheel cylinder.
Installation
NOTE: Make sure a gasket is installed between
the wheel cylinder and back plate.
To Next Page
Loading...
