Ford 2002 Bantam - A5: Check the Ignition Switch; B1: Check for Open;Short to Ground on Circuit 75 (Ye)

211-05-100 Steering Column Switches 211-05-100
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Measure the resistance between the ignition
switch connector C61 pin 4, circuit 30 (RD) and
fuse 40 connector pin 1, circuit 30 (RD).
• Is the resistance less than 5 ohms?
 Yes
GO TO A5
 No
REPAIR circuit 30 (RD). TEST the system
for normal operation
A5: CHECK THE IGNITION SWITCH
1 Carry out the ignition switch component test as
described in this section.
• Does the ignition switch test OK?
 Yes
VERIFY the customer concern.
 No
INSTALL a new ignition switch. TEST the
system for normal operation.
PINPOINT TEST B: NO POWER IN ACC
CONDITIONS DETAILS/RESULTS/ACTIONS
B1: CHECK FOR OPEN /SHORT TO GROUND ON CIRCUIT 75 (YE)
1.
Ignition switch
connector C61
2.
Fuse 19 (10A)
3 Measure the resistance between the ignition
switch connector C61 pin 1, circuit 75 (YE) and
ground, and between the ignition switch
connector C61 pin 1, circuit 75 (YE) and the
fuse 19 (10A).
• Is the resistance between connector C61 pin 1,
circuit 75 (YE) and ground greater than 10,000
ohms, and is the resistance between connector
C61 pin 1, circuit 75 (YE) and the fuse 19 (10A)
less than 5 ohms?
 Yes
INSTALL a new ignition switch. TEST the
system for normal operation.
 No
REPAIR circuit 75 (YE). TEST the system
for normal operation.
E1227 EN 07/2001 2002 Bantam