Ford 2002 Bantam - Air Bag Module Does Not Respond to the Wds

418-00-4 Module Communications Network 418-00-4
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Measure the resistance between instrument
cluster, connector C37, pin 9, circuit 4-EE8
(GY/VT), harness side and data link connector
C31, pin 7, circuit 4-DA1 (GY), harness side.
• Is the resistance less than 2 ohms?
 Yes
CHECK the instrument cluster. If necessary
INSTALL a new one. TEST the system for
normal operation.
 No
REPAIR the open circuit(s) between instru-
ment cluster and data link connector by us-
ing the wiring diagrams. TEST the system
for normal operation.
PINPOINT TEST C: AIR BAG MODULE DOES NOT RESPOND TO THE WDS
CONDITIONS DETAILS/RESULTS/ACTIONS
C1: CHECK THE ISO 9141 LINE TO THE AIR BAG MODULE FOR OPEN
1. 2.
Air bag module
C330
3 Measure the resistance between air bag
module, connector C334, pin 7, circuit 4-JA7
(GY/RD), harness side and data link connector
C31, pin 7, circuit 4-DA1 (GY), harness side.
• Is the resistance less than 2 ohms?
 Yes
CHECK the air bag module. If necessary
INSTALL a new one. TEST the system for
normal operation.
 No
REPAIR the open circuit(s) between instru-
ment cluster and data link connector by us-
ing the wiring diagrams. TEST the system
for normal operation.
E9429 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL