211-05-99 Steering Column Switches 211-05-99
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
A2: CHECK FUSE 40 (60A)
1.
Fuse 40 (60A)
2 Check the fuse 40 (60A).
• Is the fuse OK?
Yes
GO TO A4
No
INSTALL a new fuse 40 (60A). TEST the
system for normal operation. If the fuse fails
again GO TO A3
A3: CHECK CIRCUIT 30 RD) FOR SHORT TO GROUND (
1.
Fuse 40 (60A)
2 Measure the resistance between the fuse 40
connector pin 1, circuit 30 (RD) and ground.
• Is the resistance greater than 10,000 ohms?
Yes
GO TO A2
No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
A4: CHECK FOR OPEN ON CIRCUIT 30 (RD)
1.
Fuse 40 (60A)
2.
Ignition switch con-
nector C61
E1227 EN 07/2001 2002 Bantam
To Next Page
Loading...
