308-03-49 Manual Transaxle 308-03-49
IN-VEHICLE REPAIR
E1157 EN 07/2001
Input Shaft Oil Seal
Special Tool(s)
Remover, oil seal
303-336 (21-151)
Material
Specification
Self-tapping screw 2,5
x 15 mm
Removal
All vehicles
1. Remove the clutch slave cylinder.
1. Remove the bolts.
2. Detach the clutch slave cylinder from the
clutch housing.
2. NOTE: Also see the following job step.
Punch mark the input shaft oil seal
• Punch mark the input shaft oil seal using
the special tool.
3. NOTE: Carry out this step only in the position
shown.
Remove the input shaft oil seal (cont.).
1. Input shaft
2. Radial oil seal
3. Closed ball bearing
To Next Page
Loading...
