308-03-50 Manual Transaxle 308-03-50
IN- VEHICLE REPAIR (CONTINUED)
E1157 EN 07/2001
4. CAUTION: Do not damage the input
shaft ball bearing.
Remove the drive halfshaft oil seal.
1. Screw a 2,5 x 15 mm self-tapping screw
a maximum of two turns into the input
shaft oil seal.
2. Lever out the input shaft oil seal.
Installation
1. Fit the drive halfshaft oil seal and the clutch
slave cylinder.
1. Position the input shaft oil seal.
2. Position the clutch slave cylinder.
3. Tighten the bolts evenly. In doing so,
press the input shaft oil seal into the
transmission housing.
To Next Page
Loading...
