211-02-55 Power Steering 211-02-55
REMOVAL AND INSTALLATION
Steering Gear Pinion Oil Seal (13 468 0)
Special Tool(s)
Adaptor for 16-042A-01
16-042A
Remover, oil seal
21-143
Special Tool(s)
Remover, oil seal
21-151
Material
Specification
Grease power steering
gear
ESA-MIC45-A
Removal
1. Remove the steering gear
(refer to
procedure contained in this section).
2. Remove the water splash shield from the
pinion shaft.
3.
CAUTION: Make sure the pinion shaft
or oil seal housing is not damaged.
CAUTION: Make sure no particles of the
seal enter the steering gear.
Drive a hole into the dust cap approximately
3 mm from the outer edge.
E5858 EN 07/2001 2002 Bantam
To Next Page
Loading...
