206-00-7 Brake System — General Information 206-00-7
E1092 EN 07/2001 2002 Bantam
PINPOINT TEST B: BRAKE WARNING INDICATOR ALWAYS ON
CONDITIONS
DETAILS/RESULTS/ACTIONS
B1: CHECK BRAKE WARNING INDICATOR
NOTE: The brake-warning indicator should only illuminate when the ignition switch is in the START or
RUN position and the parking brake is applied.
1.
2 Release the parking brake.
- Check the fluid level in the reservoir is at the
MAX mark.
• Does the brake warning indicator illuminate?
Yes
REFER to Section 413-01.
No
GO TO B2
B2: CHECK BRAKE SYSTEM FOR LEAKAGE
1 Check the brake master cylinder reservoir
sealing points and external brake and clutch
system for leaks.
Refer to the brake master
cylinder component tests in this section.
• Does the system leak?
Yes
REPAIR as necessary. ADD fluid and
BLEED the brake system.
REFER to Section 206-00.
TEST the system for normal operation.
No
GO TO B3
To Next Page
Loading...
