Ford 2002 Bantam - A Single Mirror Is Inoperative

501-09-4 Rear View Mirrors 501-09-4
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the resistance between the exterior
mirror control switch C325 pin 3, circuit 9-AD1
(BN/RD) harness side, and the driver door A-
pillar C24 pin 3, circuit 9-AD17 (BN/GN)
harness side.
• Is the resistance less than 5 ohms?
 Yes
VERIFY the customer concern.
 No
REPAIR circuit 9-AD1 (BN/RD). TEST the
system for normal operation.
PINPOINT TEST B: A SINGLE MIRROR IS INOPERATIVE
CONDITIONS DETAILS/RESULTS/ACTIONS
B1: CHECK FOR CONTINUITY TO THE INOPERATIVE EXTERIOR MIRROR
1.
Exterior Mirror
Control Switch
C325
2 Measure the resistance between:
NOTE: Driver Exterior Mirror
- the exterior mirror control switch C325 pin 3,
circuit 9-AD1 (BN/RD) and pin 2, circuit 10-
AD8 (GY/VT) harness side.
NOTE: Passenger Exterior Mirror
- the exterior mirror control switch C325 pin 3,
circuit 9-AD1 (BN/RD) and pin 1, circuit 10-
AD11 (GY/WH) harness side.
• Is the resistance less than 50 ohms?
 Yes
VERIFY the customer concern.
 No
Driver side INSTALL a new exterior mirror.
Passenger side GO TO B2
B2: CHECK CIRCUIT 9-AD17 (BN/GN) FOR CONTINUITY
1.
Passenger Exte-
rior Mirror C311
07/2001 2002 Bantam