Ford 2002 Bantam - Brake Pedal

206-06-6 Hydraulic Brake Actuation 206-06-6
REMOVAL AND INSTALLATION
E5852 EN 03/2001 2002 Bantam
Brake Pedal (12 133 0)
Removal
1. Disconnect the battery ground cable.
For additional information,
refer to Section 414-01.
2. Remove the stop lamp switch.
3. Disengage the clutch pedal return spring.
4. Remove the brake pedal.
1. Remove the brake pedal cross-shaft
retaining clip (clutch side).
2. Push the brake pedal cross-shaft
towards the brake pedal.
3. Remove the brake pedal cross-shaft
retaining clip (brake side).
4. Push the brake pedal cross-shaft
towards the clutch and remove the brake
pedal.
5. Remove the brake pedal bushings.