Ford 2002 Bantam - The Fog Lamps Are on Continuously

417-01-71 Exterior Lighting 417-01-71
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Measure the resistance between front fog
lamp, right-hand side, connector C183, pin 2,
circuit 31-LD17 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
REPAIR the open circuit(s) between relay –
fog lamp and front fog lamp, right-hand side,
by using the wiring diagrams. TEST the
system for normal operation. If necessary
INSTALL a new front fog lamp.
 No
REPAIR the open circuit(s) between front
fog lamp, right-hand side and ground G9, by
using the wiring diagrams. TEST the system
for normal operation. If necessary INSTALL
a new front fog lamp.
PINPOINT TEST U: THE FOG LAMPS ARE ON CONTINUOUSLY
CONDITIONS DETAILS/RESULTS/ACTIONS
U1: CHECK THE FRONT FOG LAMP SWITCH FOR PROPER FUNCTION
1.
Front fog lamp
switch C328
2 Turn the multifunction switch to the PARKING
LIGHT position.
3.
4 Check if the front fog lamps are on
continuously.
• Are the front fog lamps on continuously?
 Yes
GO TO U2
 No
INSTALL a new front fog lamp switch. TEST
the system for normal operation.
E9428 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL