Ford 2002 Bantam - Page 1394

417-01-70 Exterior Lighting 417-01-70
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Determine the inoperative front fog lamp.
• Is the front fog lamp, left-hand side
inoperative?
 Yes
GO TO T2
 No
GO TO T3
T2: CHECK THE GROUND CONNECTION OF FRONT FOG LAMP, LEFT-HAND SIDE
1. 2.
Front fog lamp, left-
hand side C184
3 Measure the resistance between front fog
lamp, left-hand side, connector C184, pin 2,
circuit 31-LD11 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
REPAIR the open circuit(s) between relay –
fog lamp and front fog lamp, left-hand side,
by using the wiring diagrams. TEST the
system for normal operation. If necessary
INSTALL a new front fog lamp.
 No
REPAIR the open circuit(s) between front
fog lamp, left-hand side and ground G9, by
using the wiring diagrams. TEST the system
for normal operation. If necessary INSTALL
a new front fog lamp.
T3: CHECK THE GROUND CONNECTION OF FRONT FOG LAMP, RIGHT-HAND SIDE
1. 2.
Front fog lamp,
right-hand side
C183
E9428 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL