501-20B-40 Occupant Restraints — Passive — Supplemental Air 501-20B-40
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
PINPOINT TEST S: DTC B1880: PASSENGER SAFETY BELT PRETENSIONER CIRCUIT
CAPACITANCE OUT OF RANGE
CONDITIONS
DETAILS/RESULTS/ACTIONS
WARNING: Wait at least one minute after disconnecting the battery ground cable before
disconnecting any supplemental restraint system electrical connector. Failure to follow this
instruction may result in personal injury.
S1: CHECK THE PASSENGER SAFETY BELT PRETENSIONER CAPACITANCE
1 Deactivate the supplemental restraint system.
REFER to Air Bag and Safety Belt Preten-
sioner Supplemental Restraint System (SRS)
in this section.
2.
3 Carry out the self-test with the simulators
installed.
• Does the system prove out correctly?
Yes
INSTALL a new passenger safety belt
pretensione
r. REFER to Section 501-20A.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
No
CHECK that the safety belt pretensioner
simulator is installed correctly. REPEAT the
self-test; CLEAR the DTCs. REACTIVATE
the system. REFER to Air Bag and Safety
Belt Pretensioner Supplemental Restraint
System (SRS) in this section.
PINPOINT TEST T: DTC B1881: PASSENGER SAFETY BELT PRETENSIONER OPEN CIRCUIT
CONDITIONS
DETAILS/RESULTS/ACTIONS
WARNING: Wait at least one minute after disconnecting the battery ground cable before
disconnecting any supplemental restraint system electrical connector. Failure to follow this
instruction may result in personal injury.
T1: CHECK THE PASSENGER SAFETY BELT PRETENSIONER CIRCUIT
1 Deactivate the supplemental restraint system.
REFER to Air Bag and Safety Belt Preten-
sioner Supplemental Restraint System (SRS)
in this section.
08/2001 2002 Bantam
To Next Page
Loading...
