Ford 2002 Bantam - D5: Check the Start Inhibit Relay Ground; D6: Check the Start Inhibit Relay Power Feed

211-05-105 Steering Column Switches 211-05-105
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Measure the resistance between the ignition
switch connector C61 pin 3, circuit 50 (GY) and
ground, and between the ignition switch
connector C61 pin 3, circuit 50 (GY) and the
start inhibitor relay connector C163 pin 2,
circuit 50 (GY).
• Is the resistance between connector C61 pin 3,
circuit 50 (GY) and ground greater than 10,000
ohms, and is the resistance between connector
C61 pin 3, circuit 50 (GY) and pin 2, circuit 50
(GY) less than 5 ohms?
 Yes
GO TO D5
 No
REPAIR circuit 50 (GY). TEST the system
for normal operation.
D5: CHECK THE START INHIBIT RELAY GROUND
1 Measure the resistance between the start
inhibit relay connector C163 pin 1, circuit 315
(BK/RD) and ground.
• Is the resistance between 45 and 50 ohms?
 Yes
GO TO D6
 No
REPAIR circuit 315 (BK/RD). TEST the sys-
tem for normal operation.
D6: CHECK THE START INHIBIT RELAY POWER FEED
1 Measure the voltage between the start inhibit
relay connector C163 pin 5, circuit 30 (RD) and
ground.
• Is the voltage greater than 10 volts?
 Yes
GO TO D7
 No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
E1227 EN 07/2001 2002 Bantam