303-03-168 Engine Cooling 303-03-168
GENERAL PROCEDURES
E2465 EN 07/2001 2002 Bantam
Cooling System Draining, Filling and Bleeding (24 122 0)
Drain
1.
WARNING: When releasing the system
pressure, cover the expansion tank
cap with a thick cloth to prevent the
possibility of coolant scalding.
Relieve the cooling system pressure.
• Unscrew the cap slowly.
2. Remove the cap.
3. Raise and support the vehicle. For
additional information, refer to Section 100-
02.
4. Remove the radiator undershield.
5. Remove the drain plug.
• Drain the coolant into a suitable
container.
6. Refit the drain plug when all coolant has
drained.
7. Refit the radiator undershield.
8. Lower the vehicle.
To Next Page
Loading...
