417-01-32 Exterior Lighting 417-01-32
DIAGNOSIS AND TESTING
Turn Signal and Hazard Lamps
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of
mechanical or electrical damage.
Visual Inspection Chart
Electrical
• Fuse(s).
• Bulb(s).
• Wiring harness.
• Electrical connector(s).
3. If an obvious cause for an observed or
reported concern is found, correct the cause
(if possible) before proceeding to the next
step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
Symptom Chart
Condition
Possible Sources
Action
• Turn signal lamps are inopera-
tive or on continuously.
• Fuse F17.
• Circuit(s).
• Multifunction switch.
• Hazard warning switch.
• Instrument cluster.
• Go To Pinpoint Test K
• Hazard lamps are inoperative or
on continuously.
• Fuse(s).
• Circuit(s).
• Hazard warning switch.
• Go To Pinpoint Test M
• One turn signal/hazard lamp is
inoperative.
• Circuit(s).
• Hazard warning switch.
• Instrument cluster.
• Turn signal lamp.
• Go To Pinpoint Test L
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
To Next Page
Loading...
