417-01-73 Exterior Lighting 417-01-73
REMOVAL AND INSTALLATION
Headlamp Assembly (32 115 0)
Removal
1. Remove the front bumper. For additional
information, refer to Section 501-19.
2. Remove the headlamp assembly (left-hand
side shown).
• Disconnect the headlamp assembly
electrical connector.
Installation
1. NOTE: Position the headlamp assembly with
the guide pin.
To install, reverse the removal procedure.
2. Adjust the headlamps. For additional
information, refer to Headlamp Adjustment
in this section.
E6756 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
To Next Page
Loading...
