501-14-12 Handles, Locks, Latches and Entry Systems 501-14-12
REMOVAL AND INSTALLATION
E6000 EN 08/2001 2002 Bantam
Door Latch Remote Control
Removal
1. Disconnect the battery ground cable.
2. Remove the door trim panel. For additional
information,
refer to Section 501-05.
3.
CAUTION: Do not touch the
watershield adhesive surfaces, as re-
bonding will be impaired.
Locally peel back the trim watershield.
• Using a plastic knife, (disposable cutlery)
cut through the Butyl strip to enable the
protective sheet to be peeled back for
access. Do not attempt to peel the sheet
from the door without cutting the butyl.
4. Unclip and detach the remote control lever
and cable from the door.
5. Disconnect the lock actuating cable.
• Align the inner cable nipple with the
outer cable clip molding. Push the nipple
up to remove both inner and outer cables
from the handle.
Installation
1. To install, reverse the removal procedure.
To Next Page
Loading...
