211-05-104 Steering Column Switches 211-05-104
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Check the fuse 36 (60A).
• Is the fuse OK?
Yes
GO TO D3
No
INSTALL a new fuse 36 (60A). TEST the
system for normal operation. If the fuse fails
again GO TO D2
D2: CHECK FOR SHORT TO GROUND ON CIRCUIT 30 (RD)
1.
Fuse 36 (60A)
2 Measure the resistance between the fuse 36
(60A) connector pin 1, circuit 30 (RD) and
ground.
• Is the resistance greater than 10,000 ohms?
Yes
GO TO D1
No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
D3: CHECK THE IGNITION SWITCH
1 Carry out the ignition switch component test.
Refer to the procedure in this section.
• Does the ignition switch test OK?
Yes
GO TO D4
No
INSTALL a new ignition switch. TEST the
system for normal operation.
D4: CHECK FOR SHORT/OPEN ON CIRCUIT 50 (GY)
1.
Start inhibit relay
C163
2.
Ignition switch C61
E1227 EN 07/2001 2002 Bantam
To Next Page
Loading...
