204-03-2 Wheels and Tyres 204-03-2
DESCRIPTION AND OPERATION
E1074 EN 07/2001 2002 Bantam
Safety Precautions
WARNING: Do not mix different types of
tyres on the same vehicle such as radial,
bias or bias belted tyres except in
emergencies (temporary spare usage).
WARNING: Never run the engine with one
wheel off the ground, for example when
changing a wheel. The wheel resting on
the ground may cause the vehicle to
move.
WARNING: Aftermarket aerosol tyre
sealants are extremely flammable.
Always question the customer to make
sure that these products have not been
used.
WARNING: Always wear safety goggles
or a face shield when performing any
work with wheel and tyre assemblies.
WARNING: Retighten the wheel nuts at
800 Km after any wheel change or
anytime the wheel nuts are loosened.
WARNING: Failure to retighten the wheel
nuts at the specified mileage could
cause the wheels to come off while the
vehicle is in motion.
WARNING: Each individual axle, wheel
and tyre has its own maximum weight or
tyre inflation rating. Do not overload or
over-inflate beyond the capacity of the
lowest rated components of the system.
CAUTION: Do not clean aluminum wheels
with steel wool, abrasive type cleaners or
detergents.
CAUTION: Reduce air pressure as much
as possible by pushing the valve core
plunger in before removing the valve
core.
Failure to follow these instructions can result in
personal injury.
To Next Page
Loading...
