417-01-65 Exterior Lighting 417-01-65
DIAGNOSIS AND TESTING
Fog Lamps
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of
mechanical or electrical damage.
Visual Inspection Chart
Electrical
• Fuse(s).
• Bulb(s).
• Wiring harness.
• Electrical connector(s).
3. If an obvious cause for an observed or
reported concern is found, correct the cause
(if possible) before proceeding to the next
step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
Symptom Chart
Symptom Chart
Condition
Possible Sources
Action
• The fog lamps are inoperative.
• Fuse(s).
• Circuit(s).
• Relay – fog lamps.
• Front fog lamp switch.
• Central Junction Box (CJB).
• Go To Pinpoint Test S
• The individual fog lamp is i
erative.
nop-
• Bulb.
• Circuit(s).
• Front fog lamp.
• Central Junction Box (CJB).
• Go To Pinpoint Test T
• The fog lamps are on continu-
ously.
• Circuit(s).
• Relay – fog lamps.
• Front fog lamp switch.
• Go To Pinpoint Test U
Pinpoint Tests
PINPOINT TEST S: THE FOG LAMPS ARE INOPERATIVE
CONDITIONS
DETAILS/RESULTS/ACTIONS
S1: CHECK THE FUSE F14
1.
2.
Fuse F14 (CJB)
E9428 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL
To Next Page
Loading...
