303-
06
-
203
Starting System
303-06-203
DIAGNOSIS AND TESTING (CONTINUED)
E1017 EN
09/2001 2002 Bantam
A2: CHECK THE BATTERY VOLTAGE
1 Check the battery. Refer to Section 414-00.
• Is the battery OK?
Yes
GO TO A3
No
CHARGE or INSTALL a new battery as re-
quired. Refer to Section 414-00. TEST the
system for normal operation.
A3: CHECK SWITCHED POWER SUPPLY TO THE SOLENOID
1.
Solenoid single
pin
2.
3 Measure the voltage between the starter motor
solenoid connector single pin, circuit 50
(GY/BK) and ground when the starter is
operated.
• Is the voltage greater than 10 volts?
Yes
GO TO A4
No
GO TO A6
A4: CHECK B+ TO THE STARTER
1.
Pinpoint Tests
PINPOINT TEST A: THE ENGINE DOES NOT CRANK OR THE RELAY CLICKS
CONDITIONS
DETAILS/RESULTS/ACTIONS
A1: CHECK THE BATTERY CONNECTIONS
1 Inspect the battery connections for
loose/corroded connections.
• Are the battery terminals clean and tight?
Yes
GO TO
A2
No
CLEAN and TIGHTEN connections as re-
quired. TEST the system for normal opera-
tion.
To Next Page
Loading...
