Ford 2002 Bantam - Pinpoint Test F: Incorrect Tyre Wear; F1: Inspect the Tyres; F2: Check for Cupped Tyres; Pinpoint Test G: Vibration

204-00-14 Suspension — General Information 204-00-14
DIAGNOSIS AND TESTING (CONTINUED)
E1049 EN 06/2001 2002 Bantam
PINPOINT TEST F: INCORRECT TYRE WEAR
CONDITIONS DETAILS/RESULTS/ACTIONS
F1: INSPECT THE TYRES
1 Raise and support the vehicle.
REFER to Section 100-02.
- Inspect the tyres for uneven wear on inner or
outer shoulder, or saw tooth pattern.
• Is there uneven tyre wear?
 Yes
INSTALL new tyres if badly worn. CHECK
wheel alignment. TEST the system for
normal operation.
 No
GO TO F2
F2: CHECK FOR CUPPED TYRES
1 Inspect the tyres for cupping or dishing.
• Are the tyres cupped or dished?
 Yes
INSTALL new tyre(s). BALANCE and
ROTATE the tyres.
REFER to Section 204-03.
TEST the system for normal operation.
 No
Verify the customer concern.
PINPOINT TEST G: VIBRATION
CONDITIONS DETAILS/RESULTS/ACTIONS
G1: INSPECT THE TYRES
1 Raise and support the vehicle.
REFER to Section 100-02.
- Inspect the tyres for damage or excessive
wear.
• Are the tyres damaged or worn?
 Yes
INSTALL new tyres. TEST the system for
normal operation.
 No
GO TO G2