501-20B-6 Occupant Restraints — Passive — Supplemental Air 501-20B-6
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
5. Remove the passenger air bag module.
REFER to Passenger Air Bag Module in this
section.
6. Connect the passenger air bag simulator to
the harness in place of the passenger air bag
module.
7. Disconnect the driver under seat safety belt
pretensioner electrical connector.
8. Connect the driver safety belt pretensioner
simulator to the driver under seat floor
harness in place of the safety belt
pretensioner.
9. Disconnect the passenger under seat safety
belt pretensioner electrical connector.
10. Connect the passenger safety belt
pretensioner simulator to the passenger
under seat floor harness in place of the
safety belt pretensioner.
11. Connect the battery ground cable.
REFER to
Section 414-01.
Reactivation
WARNING: The air bag simulators must
be removed and the air bag modules
reconnected when reactivated to avoid
non-deployment in a collision. Failure to
follow this instruction may result in
personal injury.
1. Disconnect the battery ground cable.
REFER
to Section 414-01.
2. Wait at least one minute for the backup
power supply in the air bag control module to
deplete its stored energy.
3. Remove the driver air bag simulator from the
sub-harness at the top of the steering
column.
4. Connect and install the driver air bag module.
REFER to Driver Air Bag Module in this
section.
5. Remove the passenger air bag simulator
from the passenger air bag module harness.
6. Connect and install the passenger air bag
module. REFER to Passenger Air Bag
Module in this section.
7. Remove the driver safety belt pretensioner
simulator from the driver under seat floor
harness electrical connector.
8. Connect the driver safety belt pretensioner to
the under seat floor harness electrical
connector.
9. Remove the passenger safety belt
pretensioner simulator from the passenger
under seat floor harness electrical connector.
10. Connect the passenger safety belt
pretensioner to the under seat floor harness
electrical connector.
11. Connect the battery ground cable.
REFER to
Section 414-01.
12. Prove out the system.
Glossary
Air Bag Simulator
Air bag simulators are used to simulate air bag
module connections to the system.
Deactivate The System
Deactivate the system means to carry out
deactivatio
n. REFER to Deactivation in this
Section.
Prove Out The System
The air bag warning indicator will illuminate for
approximately three seconds.
• Fail to illuminate
• Illuminate continuously
• Flash
Reactivate The System
Reactivate the system means to carry out
reactivation. REFER to Reactivation in this
section.
Principles of Operation
Supplemental Restraint System (SRS) Operation
The supplemental restraint system is AC fired.
In the event of a severe frontal or three-quarter
frontal impact, in excess of a predetermined limit,
the driver and passenger (if equipped) front air
bag(s) will deploy.
Air bag deployment will only occur, in the event of
a severe collision when the ignition key is in the
RUN position.
08/2001 2002 Bantam
To Next Page
Loading...
