Ford 2002 Bantam - Relays; Measure the Resistance between Pin 3 and 5

417-01-26 Exterior Lighting 417-01-26
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Turn the multifunction switch to the LOW
BEAM and HIGH BEAM position.
• Are the high beam headlamps illuminated?
 Yes
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
Go To Pinpoint Test C
Component Tests
Relays
Component testing applies to the following
relays:
• Relay – low beam
• Relay – high beam
1. Check the relay contact in normal condition
Measure the resistance between pin 3 and 5
(VFE0015897).
Is the resistance less than 2 ohms?
If yes, INSTALL a new relay.
If no, GO to step 2.
2. Check relay contact in activated condition
Connect the battery power between pin 1 and 2.
Measure the resistance between pin 3 and 5
(VFE0015898).
Is the resistance less than 2 ohms?
If yes, the relay is OK.
If no, INSTALL a new relay.
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL