206-02-5 Drum Brake 206-02-5
REMOVAL AND INSTALLATION (CONTINUED)
E6594 EN 07/2001 2002 Bantam
8. NOTE: When removing the drum make sure
the wheel bearing is not displaced from its
housing.
Remove the drum.
1. Remove the nut.
2. Remove the drum.
• Ensure the wheel bearing is not
displaced from its housing.
Installation
CAUTION: Once tightened, the hub-
retaining nut must not be disturbed. If
the torque setting requires to be
checked the nut must be loosened two
full turns and re-tightened.
NOTE: Rotate the hub while tightening the hub-
retaining nut.
1. To install, reverse the removal procedure.
4. Adjust the parking brake cable.
For additional information,
refer to Section 206-05.
To Next Page
Loading...
