501-20A-8 Occupant Restraints — Active 501-20A-8
REMOVAL AND INSTALLATION
Safety Belt Buckle and Pretensioner
Removal
WARNING: Never probe the electrical
connectors of air bag modules or any
other supplemental restraint system
component. Failure to follow this in-
struction may result in personal injury.
1. Remove the front seat backrest. For
additional i
nformation, refer to Section 501-
10.
2.
CAUTION: Note the position and
routing of the safety belt buckle
pretensioner wiring harness to aid
assembly. An incorrectly routed
wiring harness may lead to the wiring
harness becoming damaged on the
seat mechanism.
Detach the safety belt buckle pretensioner
wiring harness from the underside of the
seat.
3. Remove the seat inner trim panel.
1. Remove the retaining bolt and spacer.
2. Detach the rear locating tang.
3. Slide the inner trim panel forwards to
detach the front locating tang.
4. Remove the safety belt buckle and
pretensioner.
08/2001 2002 Bantam
To Next Page
Loading...
