501-10-3 Seating 501-10-3
REMOVAL AND INSTALLATION
Front Seat
Removal
Vehicles with driver air bag
WARNING: To avoid accidental deploy-
ment the air bag control module backup
power supply must be depleted. Wait at
least one minute after disconnecting the
battery ground cable(s) before com-
mencing any repair or adjustment to the
supplemental restraint system (SRS), or
any component(s) adjacent to the SRS
sensors. Failure to follow these instruc-
tions may result in personal injury.
WARNING: Always wear safety glasses
when working on an air bag equipped
vehicle and when handling an air bag
module. Failure to follow these instruc-
tions may result in personal injury.
1. Disconnect the battery ground cable. For
additional i
nformation, refer to Section 414-
01.
All vehicles
2. Remove the head restraint.
3. Detach the seat side trim panel from the
seat track.
E9364 EN 07/2001 2002 Bantam
To Next Page
Loading...
