501-10-4 Seating 501-10-4
REMOVAL AND INSTALLATION (CONTINUED)
Vehicles with driver air bag
4. Disconnect the safety belt buckle pre-
tensioner electrical connector.
All vehicles
5. Move the seat fully rearwards.
6. Remove the seat front retaining bolts.
7. Move the seat fully forwards.
8. Remove the seat rear retaining bolts and
remove the seat.
Installation
All vehicles
1. NOTE: Do not fully tighten the seat retaining
bolts at this stage.
Install the seat.
E9364 EN 07/2001 2002 Bantam
To Next Page
Loading...
