501-16-35 Wipers and Washers 501-16-35
GENERAL PROCEDURES
Wiper Blade and Pivot Arm Adjustment (32 591 0)
Special Tool(s)
Aligner, Wiper Arm
501-027 (32-006)
Adjustment
1. Position the wiper blades in the park
position.
2. Remove the wiper blade.
• Insert the wiper arm in the aligner and
lay it on the windshield.
3. NOTE: All three points of support of the
aligner must be placed on the windshield.
NOTE: Required values: For additional
information, refer to General Specifications in
this section.
Using the special tool, read off the angle
between the wiper arm and the windshield.
4. NOTE: Lift the special tool away from the
windshield when correcting the angle, in
order to prevent damage.
Using the special tool, adjust the wiper arm.
• Using an open-ended spanner on the
special tool, adjust the angle.
5. Remove the special tool.
6. Install the wiper blade.
E3904 EN 07/2001 2002 Bantam
To Next Page
Loading...
