Ford 2002 Bantam - One or more Stop Lamps Are Inoperative

417-01-28 Exterior Lighting 417-01-28
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
H2: CHECK THE CIRCUIT TO STOP LAMP SWITCH FOR OPEN
1.
Stop lamp switch
C50
2.
3 Measure the voltage between stop lamp
switch, connector C50, circuit 14-LG23
(VT/WH), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO H3
 No
REPAIR the open circuit(s) between fuse
F13 and stop lamp switch, by using the wir-
ing diagrams. TEST the system for normal
operation.
H3: CHECK THE STOP LAMP SWITCH FOR PROPER FUNCTION
1 Connect a jumper wire between stop lamp
switch, connector C50, circuit 14-LG23
(VT/WH) and circuit 14S-LG1 (VT/BK), harness
side.
• Are the stop lamps illuminated?
 Yes
INSTALL a new stop lamp switch. TEST the
system for normal operation.
 No
REPAIR the open circuit(s) between stop
lamp switch and splice S37, by using the
wiring diagrams. TEST the system for nor-
mal operation.
PINPOINT TEST I: ONE OR MORE STOP LAMPS ARE INOPERATIVE
CONDITIONS DETAILS/RESULTS/ACTIONS
I1: DETERMINE THE FAULT CONDITION
1.
2 Depress the brake pedal.
E6752 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL