501-20B-12 Occupant Restraints — Passive — Supplemental Air 501-20B-12
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
PINPOINT TEST C: DTC B1318: BATTERY VOLTAGE LOW
CONDITIONS
DETAILS/RESULTS/ACTIONS
C1: CHECK THE BATTE Y VOLTAGE R
1.
2 Check the battery voltage.
• Is the battery voltage greater than 9 volts?
Yes
GO TO C2
No
CHECK the battery and charging system.
For additional information,
refer to the Wir
ing Diagrams, Petrol and Diesel
REPEAT the self-test,
CLEAR the DTCs.
C2: CHECK THE CONDITION OF THE FUSE
1.
Fuse 60 (10A)
2.
Fuse 60 (10A)
3 Check the condition of fuse 60 (10A).
• Is any corrosion present on the fuse or the
terminals?
Yes
CLEAN the terminals. INSTALL a new fuse
60 (10A). REPEAT the self-test, CLEAR the
DTCs.
No
GO TO C3
C3: CHECK THE AIR BAG CONTROL MODULE SUPPLY CIRCUIT
1 Deactivate the supplemental restraint system.
REFER to Air Bag and Safety Belt Preten-
sioner Supplemental Restraint System (SRS)
in this section.
2.
Air Bag Control
Module C334
08/2001 2002 Bantam
To Next Page
Loading...
