501-20B-11 Occupant Restraints — Passive — Supplemental Air 501-20B-11
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Check the security of the air bag control
module.
• Is the air bag control module correctly mounted
and all bolts tightened to the correct torque?
Yes
GO TO B2
No
TIGHTEN the air bag control module.
REFER to Specifications in this section.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner Supple-
mental Restraint System (SRS) in this sec-
tion.
B2: CHECK THE AIR BAG CONTROL MODULE GROUND CIRCUIT
1.
Air Bag Control
Module C334
2 Measure the resistance between the air bag
control module C334 pin 9, circuit 91-JA10
(BK/RD) and the air bag control module
housing.
• Is the resistance less than 5 ohms?
Yes
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
No
REPAIR circuit 91-JA10 (BK/RD); REMOVE
the air bag control module. REFER to Air
Bag Control Module in this section. CLEAN
the air bag control module mountings and
bolts. INSTALL the air bag control module.
REFER to Air Bag Control Module in this
section REPEAT the self-test; CLEAR the
DTCs. REACTIVATE the system. REFER
to Air Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
08/2001 2002 Bantam
To Next Page
Loading...
