Ford 2002 Bantam - The Heater Blower System Is Inoperative

412-00-20 Climate Control System — General Information 412-00-20
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
B23: CHECK THE CIRCUIT 31S-CA12 (BK/BU) FOR OPEN
1 Measure the resistance between A/C
compressor cycling switch, connector C91, pin
1, circuit 31S-CA17 (BK/RD), harness side and
dual pressure switch, connector C77, pin 2,
circuit 31S-CA12 (BK/BU), harness side.
• Is the resistance less than 2 ohms?
 Yes
GO TO B24
 No
REPAIR the open circuit(s) between dual
pressure switch and PCM by using the wir-
ing diagrams. TEST the system for normal
operation.
B24: CHECK THE A/C INHIBIT DIODE
1 Check the A/C inhibit diode referring to the
diode test.
• Is the A/C diode OK?
 Yes
REPAIR the open circuit(s) between dual
pressure switch and relay – A/C switch by
using the wiring diagrams. TEST the system
for normal operation.
 No
INSTALL a new A/C inhibit diode. TEST the
system for normal operation.
PINPOINT TEST C: THE HEATER BLOWER SYSTEM IS INOPERATIVE
CONDITIONS DETAILS/RESULTS/ACTIONS
C1: DETERMINE THE FAULT CONDITION
1.
2 Turn the heater blower switch from SLOW
SPEED to HIGH SPEED position.
3 Check the airflow.
• Is the heater blower in all positions
inoperative?
 Yes
GO TO C2
 No
GO TO C8
E9425 EN 07/2001 2002 Bantam