501-09-3 Rear View Mirrors 501-09-3
DIAGNOSIS AND TESTING
PINPOINT TEST A: THE MIRRORS ARE INOPERATIVE
CONDITIONS
DETAILS/RESULTS/ACTIONS
A1: CHECK THE VOLTAGE TO THE EXTERIOR MIRROR CONTROL SWITCH CIRCUIT 29-AD12
(OG/YE)
1.
Exterior Mirror
Control Switch
C325
2 Measure the voltage between the exterior
mirror control switch C325 pin 6, circuit 29-
AD12 (OG/YE), harness side and ground.
• Is the voltage greater than 10 volts?
Yes
GO TO A2
No
REPAIR circuit 29-AD12 (OG/YE). TEST
the system for normal operation.
A2: CHECK CIRCUIT 31-AD12 (BK) FOR CONTINUITY
1 Measure the resistance between the exterior
mirror control switch C325 pin 4, circuit 31-
AD12 (BK), harness side and ground.
• Is the resistance less than 5 ohms?
Yes
GO TO A3
No
REPAIR circuit 31-AD12 (BK). TEST the
system for normal operation.
A3: CHECK CIRCUIT 9-AD1 (BN/RD) FOR CONTINUITY
1.
Driver Door A - pil-
lar C24
07/2001 2002 Bantam
To Next Page
Loading...
