415-01-3 Audio Unit 415-01-3
REMOVAL AND INSTALLATION
E1314 EN 07/2001 2002 Bantam
Audio Unit (38 222 0)
General Equipment
Radio removal tool
Removal
NOTE: Make a note of the audio keycode and
the preset radio stations before disconnecting
the audio control unit.
1. Detach the audio unit.
1. Insert the radio removal tools into the
locating holes until they click into place.
2. Pull the tools gently towards the side of
the unit to release the locking tangs.
3. Pull the unit out of the instrument panel.
2. Remove the audio unit.
• Disconnect the electrical connectors.
• Disconnect the antenna lead.
Installation
1. NOTE: When installing the audio unit make
sure the rear support engages on the carrier.
To install, reverse the removal procedure.
• Enter the audio unit keycode and
reprogram the preset radio stations.
To Next Page
Loading...
