Ford 2002 Bantam - Passenger Safety Belt Pretensioner Short to Battery

501-20B-42 Occupant Restraints — Passive — Supplemental Air 501-20B-42
Bag System
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
4 Measure the resistance between:
- the air bag control module C335 pin 20,
circuit 94S-JA34 (VT/OG) and the passenger
safety belt pretensioner C347 pin 3, circuit
94S-JA34 (VT/OG) harness side; and
- the air bag control module C335 pin 21,
circuit 91S-JA34 (BK/RD) and the passenger
safety belt pretensioner C347 pin 1, circuit
91S-JA43 (BK/RD) harness side.
• Are the resistances less than 5 ohms?
 Yes
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS) in
this section.
 No
INSTALL a new air bag wiring harness.
REPEAT the self-test; CLEAR the DTCs.
REACTIVATE the system. REFER to Air
Bag and Safety Belt Pretensioner Supple-
mental Restraint System (SRS) in this sec-
tion.
PINPOINT TEST U: DTC B1882: PASSENGER SAFETY BELT PRETENSIONER SHORT TO
BATTERY
CONDITIONS DETAILS/RESULTS/ACTIONS
WARNING: Wait at least one minute after disconnecting the battery ground cable before
disconnecting any supplemental restraint system electrical connector. Failure to follow this
instruction may result in personal injury.
U1: CHECK THE PASSENGER SAFETY BELT PRETENSIONER CIRCUIT
1 Deactivate the supplemental restraint system.
REFER to Air Bag and Safety Belt Preten-
sioner Supplemental Restraint System (SRS)
in this section.
2.
08/2001 2002 Bantam